Abstract:
Before the advent of medical imaging, palpation was one of the malO methods to detect
abnormalities in the body, mainly because the mechanical properties of diseased tissue are
typically different than that of the healthy tissue surrounding it. Utilizing the same concept of
palpation now ultrasound elasticity imaging technique is a promising new tool for cancer
diagnosis and management. Ultrasound is applied to sense small local tissue deformations
noninvasively to image stiffness and thus exploit the large intrinsic stiffness contrast generated
during the progression of many diseases. Elasticity (strain) images are generally computed by
measuring the local deformation due to the controlled application of static tissue compressive
force. Local deformation is estimated by two techniques. One is correlation technique and
another is compression technique. Correlation based strain imaging is efficient in cancer detection for its simplicity and lower cost but large displacement estimation error occurs in this
technique. Therefore, in our thesis we investigate direct compression technique for strain
imaging that provide significantly better image for cancer detection. But compression technique
has a limitation in cancer detection which is computational cost. Computational cost is higher in
compression technique. To overcome this limitation we apply frame wise compression technique
which made the algorithm faster. In our work, we construct an elasticity image from the radio
frequency ultrasound signals acquired before and after applying a physical pressure in the region
of interest. We observe that, normal B-mode image cannot detect the cancer or hard tissue
surrounding by normal tissue. On the other hand, strain image can detect cancer or hard tissue
surrounding by normal tissue. For this reason people are trying to incorporate strain imaging
technique in ultrasound equipment commercially. Therefore strain/elasticity imaging is now
showing potential in early cancer detection.
Description:
This thesis submitted in partial fulfillment of the requirements for the degree of B.Sc in Electrical and Electronic Engineering of East West University, Dhaka, Bangladesh.